Makin' your own bacon

It may seem like a redundant thing to do. Bacon is easily obtainable from shops, so why would anyone make their own? My reasoning is: "Because it's amazing".

It's almost unreal. That bacon, perhaps the most beloved form of cured meats, is really easy to make. Easy enough, that I generally make anywhere between 4-12Kg at a time, so I'm ready for unexpected visitors, barbecue events, "just 'coz", or the Kosher apocalypse.

Ready for the broad strokes on dry curing some bacon?

You need:

Equipment:

Ingredients:

Method:

  1. Evaluate the size of your food saver roll or zip lock bags and cut your pork into nice (square) pieces that will comfortably fit inside them.
  2. Weigh each piece of meat, and note it down. I generally use a permanent marker and write on the bag/vacuum sealed roll.
  3. For each piece, accurately weigh the amount of cure needed using the following formula: Number of kilograms (Kg) x 40 grams. (If you have 2.25Kg, that's 2.25x40g = 90g)
  4. Rub the entire surface of that particular meat with measured cure, making sure you get into all the nooks and crannies.
  5. Put the meat in your zip lock bag and try to squeeze out as much air as possible, seal it up fully. If you're not sure about the seal, feel free to use tape on your bag to create a stronger or secondary seal. Alternatively, vacuum seal your now coated slab of meat. Just make sure than none of the cure forms a lump where the sealer might actually want to run the seal across. I've had this issue, and had to seal it a second time in a different location.
  6. Put the pieces in the fridge horizontally. (I generally try to keep them all fatty side up, or all meat side up so I can keep track of which ones I have flipped over.
  7. For every 500g of meat, you need to cure each piece of meat in the fridge for a day. Minimum 4 days, max 8.  Flip it over once a day.
  8. After a day or two, you'll notice a fluid building up, this is good. Do not drain it. Just keep flipping it over once a day until you've cured it for the appropriate length of time.
  9. When you've reached the end. Take the meat out, and wash the excess off under running water.
  10. Soak your meat in a fresh batch of ambient-temperature water (in a sink or container) for 1 hour to further remove any excess cure.
  11. Pull the meat out of the water, and pat it dry with paper towel or a clean cloth.
  12. Put each piece of meat uncovered in the fridge. (I use wire cooling racks for maximum airflow) Some people say you can get away with just 6 hours, but I generally prefer to leave it overnight, up to 24 hours. Leaving it uncovered, you'll notice a shiny skin developing on the meat. This is called "pellicle" and if you like smokey bacon, you really want this to develop properly. This is what the smoke flavour will attach itself to.
  13. Now it's time for the pre-cook.This method is for "Hot smoking", and is generally the easiest to do with the stuff people have lying around.
    • If you're using an oven, then the best way to add smoke flavour is to use liquid smoke (trust me you don't want to be setting fire to wood chips inside).
      • Turn the oven to 110 degrees, spray the meat with liquid smoke, and put it in when the oven is at 110 Celsius.
      • You could use a meat hanger to cook the meat in the oven, but again, I just put it horizontally on the shelves with a drip tray underneath, and it works fine.
      • Regularly check the internal temperature of the meat with a meat thermometer. When you get to 65 degrees Celsius, you're done! Pull it out and allow to cool.
    • For better results, I recommend a smoker or charcoal barbecue, feel free to add wood chips, (some say maple or hickory woods, or some sort of fruit woods such as apple, cherry). I'm quite partial to apricot and plum wood chips myself... or if you're using natural charcoal, you can skip the chips and just use the regular smoke from a natural charcoal barbecue. I generally go for a "low and slow" temperature (somewhere around the 110-125 degrees Celsius mark).
      • Again, I've never used a meat hanger for the barbecue, so I just put the meat on the grill and that works fine. I let the drips fall into the fire, it creates a lovely smokey effect. However, I do use heat deflectors (ceramic shields) to stop the barbecue from grilling, and allow a more "baking" experience to occur.
      • If you use a meat thermometer you can check on it regularly until it reaches 65. If you're fortunate enough to have a barbecue controller, you can stick your food probe(s) into the respective pieces of meat, set it to 65, and it'll let you know when it's ready.
  14. Once it's pre-cooked. Allow the meat to cool to a slicing-friendly temperature.
  15.  Slice your slabs into slices. Some people like thin slivers/rashers like you get in shops to maximize the "crispiness", others prefer bacon steaks that are simply made with thicker slices. Others like the middle ground and go for chunky/rustic slices of uneven thickness.(Some crispy edges, some thick and moist pieces of bacon too). In any case, your bacon is going to be better than most store bought varieties.
  16. Once sliced, feel free to cook some as a test sample (we can't skip this critical step in our home). As for the rest, we generally lay them out flat in vacuum packs, and seal them up for quick defrosting and longer term storage.
  17. Enjoy your home made bacon. Feel free to add flavourings! There are tons of sites on the Internet with suggestions.

 Here's some images from my procedure:

Rubbing the cure all over your meat, working into every nook and cranny
Image 1: Rubbing the cure all over your meat, working into every nook and cranny. The yellowish tinge is not "chicken salt" as many might believe but the maple flavouring in the cure.

 

Allowing the bacon to cure in the bag
Image 2: Allowing the bacon to cure in the bag, flipping over ever day, you'll see the rub mix with the meat juices to make a yellow brine in the bag. Do NOT drain.

 

Image 3: Once the curing is finished, wash the excess cure off under running water, then allow the meat to soak in ambient water for 1 hour. Remove, pat dry leave the meat uncovered in the fridge overnight. This forms a shiny coating called the "pellicle" (sort of a pearl-shininess shown above) which is what you need to smoke this delicious chunk of meat.

 

Image 4: Firing up a charcoal barbecue, (waiting for it to burn cleanly) and heating to 110 degrees Celsius, I chose to throw on some apple wood chips for smoking. Here you can see that I haven't set the meat probe temperature correctly. The set temperature should be 65. We still have some way to go.
Image 5: I've fixed the set temperature, and now we're getting closer to the final internal temperature.

 

Image 6: This was the thickest piece of pork belly, and as such it took the longest to get to temperature. I've taken the other pieces off as necessary. When done, take off all the pieces and allow to cool.
Image 7: We have cats, so giant slabs of bacon cooling on the bench is a terrible idea. So we just stick the meat in the (cold) oven for an hour or two.
Image 7: We have cats, so giant slabs of bacon cooling on the bench is a terrible idea. We just stick the meat in the (cold) oven for an hour or two.
Image 8: You could use a meat slicer here, but I just use a knife to cut the belly into chunky/rustic (if rustic = "wonky") steaks of bacon.
Image 9: Once sliced, we simply lay them out in a flattish way in vacuum sealed bags, (for storage efficiency, and defrosting ease) then freeze them. Here is a stack of 7/8 servings of bacon, all from one small piece of pork belly. Sorry about the blurriness of this shot. I actually had been barbecuing all day, with the bacon, the roast for our lunches through the week, and some steaks for dinner. It was getting pretty late, and the light was not bright enough for a hand held shot.

 

 

 I'll add more photos when I make something photogenic enough to be interesting. :~)